ELECTRO-LUBER™ is the most widely-used single point unit with extensive safety ratings. This unit can be used underwater, in mines, and other hazardous areas.
JACK LUBER™ is a cost-efficient and powerful unit, pushing lubricant up to 200psi. It operates under extreme temperatures (-20°C – +60°C).
ULTIMATE-LUBER™ is a powerful lubricator, pushing over 1000psi and servicing up to 12 lube points. With high pressure, this unit can run a 10m feed line.
TITAN CL & TITAN II can push over 1000psi through up to 12 points, and uses convenient grease cartridges.
TITAN OILER is an extremely powerful unit, pushing over 2000psi. With extremely high pressure, this unit can feed 12 points with long feed lines.
Remote Control is used to turn the luber unit ON and OFF for specific periods of time. These settings are pre-determined and programmed by the user.
Our Remote Control option is a specially programmed circuit board that is housed within the unit. The circuit board connects via low voltage wires to a relay or PLC (customer supplied) that controls the lubricator‘s cycle timing. It is then programmed by, and controlled by, the customer to operate when the machinery does.
A plant runs between 7am and 5pm and all machinery shuts down for 60 minutes during lunch. The luber is programmed to go into pause mode when machinery is not in operation. The switch receives a signal from the controlling device the contact opens, pausing the lubrication cycle.
When the machinery is active, the lubricator will operate normally, cycling as per the installation instructions for the entire time the switch is closed. When the lubricator comes back online, it will continue from the exact point it was paused during the current cycle.
Vibration Control is used to put the luber unit into “active” mode when machinery is running, or “pause” mode when machinery is idle and the unit senses no vibration.
Remote Control turns the luber unit ON and OFF for specific periods of time. These settings are pre-determined and programmed by the user.
Motion Control allows you to program luber units into “active” or “pause” mode, dependent upon machinery operation.
Pulse Control manages the frequency of lubrication based on the rotations of the machinery—rather than regularly timed intervals.
Have questions about our remote control options? Call us Toll Free 1-800-663-8141 to discuss the best option for your situation.
Get the latest news, tips, and product updates directly into your inbox.
We don’t share your info and you can unsubscribe at anytime if you aren’t getting value from our occasional email updates.